Here Comes That Famous Wabbit!!!

Hi everyone.  I am glad we have made it through another week.  At least my family seems to be almost all well.  True to form, I woke up yesterday morning with a scratchy throat and a runny nose.  I attribute it to the wild weather we had Wednesday.  I think its just a cold so it will go away in its own time. 

I did find time yesterday to get into my craft room and make a Bugs Bunny to share with you.  So let's just jump in and get started. 

 

I started with a base card of Daffodil Delight cut at 4 1/4" x 11", scored at 5 1/2".   I added a layer of Basic Black to this with runner adhesive.  It is cut to be 4 1/8" x 5 3/8",  The final layer of the card is a piece of 4" x 5 1/4" Tempting Turquoise.  I ran this piece through the big shot using the chevron impression folder.  On the raised chevron lines, I used my 2 way glue pen to add glue and then sprinkled on an aqua glitter.  I wanted to make the background pop a little and thought this would be a way to do it.  I attached it to the black using runner adhesive. 

 

The greeting is from a stamp set I bought years ago at a craft store.  I stamped it using Tempting Turquoise ink onto Whisper White.  I then cut it out using the framelits itty bitty banners set and the big shot.  I used a pencil to curl the center and the edges of it and attached it to the card using glue dots.

 

Now for the star himself.  The colors of card stock I use to make my guy are Brushed Silver, Melon Mambo, Bravo Burgundy, Whisper White and Basic Black.  You can use a gray card stock for him but I like the look of the silver.  The base piece of his head is a 3" circle which I cut out with my big shot and 3" circle die.  I trimmed the sides in at an angle and made the top hair by snipping out little parts.  I traced the edge of the hair with a black marker to highlight it.  Here is list of punches used to make the rest of him:

Ears - large oval punch; you will need 2 silver or gray for each ear

Pink inside of Ears - full heart punch; I cut it in half and trimmed it to round the edges

Eyes - the retired small oval punch; you will need one white and one silver or gray for each eye; you could trim the large oval down if you do not have the retired small one

Black of Eyes - word window punch

Cheeks - wide oval punch; you will need 2

Chin - 1 inch circle punch

Mouth - wide oval punch; trim it to narrow on each side

Teeth - 1 inch square punch; I offset it from the card stock so that it punched a smaller rectangle

Piece above Teeth - 3/4" circle and curly label punch; punch out a curly label and set it aside.  You will not use it.  Then offset the 3/4" circle from the curly label hole and punch again.  If you do not have the curly label punch, you can punch a 3/4" circle and cut a little bigger that half.  Add the small indentation in the center and your all set.

Nose - the retired small oval punch; you will use only the tip of it for this.  If you do not have this, you can used a 1/2" circle in its place.

And there you have it.  I attached all pieces together using my 2 way glue pen.  Once everything was attached, I used a fine tip black marker to draw the lines above the nose and the one down the teeth.  I attached the completed bunny to the card using dimensionals.  

I hope you can understand and use my directions for him.  Feel free to contact me if you have any questions.  I am so happy I have finally made this fellow to share with all of you.  

I wish you all a wonderful weekend and I will be back on Monday with another card for you to see.  Thanks for dropping by today!!!!